Mobile News

OnePlus 10 Pro aluminum dummy leak, quad rear camera setup tips

The OnePlus 10 Pro has leaked into an aluminum dummy hinting at the design. The company reportedly went back to the drawing board and redesigned the camera module. These leaked renders show that the OnePlus 10 Pro has a camera module in the corner instead of in the center as it used to. The aluminum mockup of the OnePlus 10 Pro also offers the location of the volume and power buttons of the upcoming phone.

Tipster xleaks7 (David Kowalski) in partnership with Bracelets of the Depths It has a leak aluminum dummy OnePlus 10 Pro. The layout shows that the rear camera module has four sensors located inside, with a flash in the center. It can be seen that the OnePlus 10 Pro has slightly curved edges. The bottom edge houses the SIM card tray slot, USB Type-C port, and speaker grill.

Tipster claims the OnePlus 10 Pro may have a silent mode switch and a power button on the right edge, while the left edge may have volume buttons. Also, while the aluminum dummy doesn’t offer any clues, the OnePlus 10 Pro is expected to have a punch-hole display design, with a notch located in the upper left corner of the display.

This OnePlus 10 Pro aluminum dummy pretty much matches what past leaks say. The smartphone will launch in the first quarter of 2022 and could be powered by a Qualcomm Snapdragon 8 Gen 1 SoC under the hood. In addition, the smartphone is equipped with a 6.7-inch (1440×3.216 pixels) AMOLED LTPO Fluid 2 display with a 120Hz refresh rate and a pixel density of 526ppi.

The OnePlus 10 Pro leaks also suggest that the smartphone could have up to 12GB of RAM and 256GB of internal storage. There may be a 5,000mAh battery on the front of the phone.




Source link

Read More

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button